Q Switch ND YAG Laser Machine
Jun 24, 2019
Leave a message
ND YAG Laser Device Treatment Range:
* Wash blue, black embroider eyebrow
* Wash coffee embroider eyebrow
* Wash red soal lip
* Wash coloful Tattoo
* Remove freckle, age pigment
* Remove nevus of Ota/Congenital-birthmark.
Therapeutic range:
1. 1064nm Wavelength: Remove black and dark blue tattoo pigments, such as tattoos, eyebrows, dark color around the eyes, freckle, age spot etc.
2. 532nm Wavelength: Remove red and brown tattoos and red mark.
Operation tips:
1. Please adjust the power of the machine from low to high little by little according to the skin conditions to get the best treatment. Again. The laser aiming point should focus on the coloring point.1064 is for black tattoo. 532 is for colorful tattoo.
2. Please make sure the machine is filled up with water before using it or it will cause the defective of the machine.
FAQ for Q Switch ND YAG Laser tattoo removal machine:
Q: Is the Laser harmless if I see it direct?
A: We have equipt the care-protective glasses for the users.
Q: If we need to replace the water after finished the treatment every time?
A: It is no need to replace every time, unless the machine is overheated, but we need to operate it in a short time, we can choose to replace the half of hot water in the machine to cold water. The water inside of the machine is not consumed, it plays the role of cycle cooling. Users to replace the water every 30 days to 45 days interval .
Q: Treatment head cleaning
A: Clean the two treatment head softly using cotton bud in case the filter glasses is contaminated by dust or ashes.
Q: It remove all color tattoo?
A: The laser is with 1064nm & 532nm treatment heads. The 1064nm remove black, brown, cyan color pigment and the 532nm removes red, bule, coffee, yellow and other color pigment.
Q: How many times needed to remove all tattoo?
A: It depends. Some tattoo is thin and easy to remove, some are not. It depends on the tattoo and its color.
Usually it takes about 4-6 times
Q:How to maintain machine?
A: Change water each 15 days. If it is busy season, change water more frequently. Make laser have a rest after each treatment for about 10-15 minutes.
Notes:
1. A small rest is friendly to your laser. Stop doing treatment if the treatment gun becomes hot after a long time working.
2. Distill or pure water only dirt from water should stem the water pipe and make water cooling not working good.
3. Clean the handle piece after treatment (to keep good function & good result) Please turn it off when treatment is finish.

