How To Treat Using Diode Laser Hair Removal Device

1. Safety check before treatment

Safety check before operation:

View the patient's treatment record.

It is recommended to select the parameters suitable for the patient according to the patient's condition and clinical treatment guidelines.

The patient's skin preparation, such as cleaning and anesthesia.

The status of all operating procedures should be displayed on the monitor screen.

2. The treatment process

2.1 Preparation before treatment

When the patient’s skin is dark, please protect the skin from the sun, and avoid sun exposure 4-6 weeks before the treatment.

Keep the treated area clean and dry, shave the hair, remove grease and dirt.

2.2 Anesthesia

The use of anesthesia or unnecessary depends on the treatment site (if it is in a sensitive area) and the patient's sensitivity to pain.

2.3 Treatment steps

(1) Remove excess hair in the treatment area (leave 1--2mm)

(2) Clean the treatment area and disinfect the skin (apply anesthesia cream as needed before disinfection, and use anesthesia cream after using the diode laser hair removal machine proficiently to avoid burns)

(3) Apply cold gel to the treatment area with a thickness of about 2mm

(4) Adjust the treatment parameters; adjust according to the recommended parameters of the system. The general adjustment parameters follow the principle: the maximum value that the customer can tolerate for treatment (the greater the energy, the better the effect is in the case of not being burned) generally the customer can tolerate Generally, the skin will not be burned within the range. Remember not to shine twice in the same area, because the energy will accumulate and it is easy to burn the skin. After you are proficient in operating the diode lase hair removal machine, you will know how to apply anesthetic ointment to the customer. What parameters will not burn the skin, and the effect is the best.

Wear protective goggles and goggles for treatment. After finishing the treatment area, if you feel that the effect is not good, you can do it again in the treatment area, but you must not continuously emit light in the same place until the hair follicles are slightly red.

(5) After treatment, clean the skin and apply anti-inflammatory ointment, avoid water for one day, and avoid sun exposure for one week

(6) Pay attention to the cleanliness of the treatment area, wipe it with alcohol every day to avoid folliculitis

(7) Adhere to the course of treatment

Different parts of the hair have different growth cycles, so the treatment interval changes accordingly. The hair on the head is relatively short, (about 12-16 weeks). The treatment interval is 30 days, which is the period of hair development. Hair on the body and limbs, the remaining time is 12-24 weeks; the treatment interval is 60 days. Generally speaking, the best time is when the hair starts to grow.

3.3 Postoperative care and side effects

(1) Superficial skin damage appears after treatment

(2) Pigmentation or depigmentation may occur. But this complication is temporary; it will naturally recover after a few months.

(3) There will be slight pain during treatment, but it can be accepted, and local anesthetic cream can also be used. Under normal circumstances, it is not necessary to use it.

(4) Henoch-Schonlein purpura (HSP) may appear 1-3 days after treatment at the treatment site.

(5) Slight redness and swelling will appear on the treated area, but usually disappear after a few hours.